System Alarms - Circadiance SmartMonitor2 Bedienungsanleitung

System Alarms

A System Alarm indicates that the monitor may not be functioning properly or at optimum capacity. The information in this
section will help you respond appropriately to system alarms. When a SmartMonitor 2 system alarm occurs, one of the lights
at the bottom of the front panel will come on.
If this light And this condition exists
is on
Power Continuous green light, no alarm
Continuous green light, no alarm
Charger
Flashing yellow light, continuous alarm
Low Battery
Continuous yellow light, continuous
alarm
It means...
Normal operation. The green power indicator light will come on
and stay on for as long as the monitor is on.
Normal operation. The green charger light will come on and
stay on while the power cord/battery charger is plugged into an
active outlet and connected to the SmartMonitor 2.
This is a warning that the battery voltage is very low and should
be recharged soon. (See Charging the Battery in this manual).
Press the RESET button to temporarily silence the alarm. The
alarm will resound in 2 minutes if the monitor has not been
plugged in. The yellow light will continue to flash.
This is a warning that the battery is too low for the SmartMonitor
2 to operate properly. The SmartMonitor 2 must be recharged.
Turn the monitor off. Then, recharge the battery. (See Charging
the Battery in this manual).
If you do not reconnect the charger, the system will
automatically shut down.
Responding to Alarms
28