Opening The Light Box - Bosch HTD 6 serie Serviceanleitung

18. Then carefully set the post upright again. While
doing this, keep the cable under tension with the
aid of the slide shoe.
19. Reattach cover and laser visor to the post. Tighten
the screws in the cover.
20. Attach the light box to the slide shoe.
Fig. 26: Underside of light box
1 Fastening screws
i
After the cable has been replaced, the laser visor
must be calibrated again!
See section „4. Checking / calibration".
Robert Bosch GmbH
Component replacement | HTD 6xx / HTD 8xx | 83
9.2

Opening the light box

1. Loosen the socket head screw in the display housing
until the display housing can be lifted out.
Fig. 27: Light box
1 Display housing screw
2. Position the display housing on the light box so that
the two retaining screws are freely accessible.
3. Remove the two housing screws.
en
|
1 692 106 011 2019-03-26