Bosch HTD 6 serie Serviceanleitung Seite 57

8. The horizontal line of the test screen must coincide
with the horizontal laser line.
9. If the horizontal line on the test screen does not
coincide with the horizontal laser line, turn the ad-
justment wheel until they match. Loosen the adjust-
ment wheel with an Allen key and rotate to "Zero".
Tighten the adjustment wheel again and check the
setting.
10. Switch on the laser visor.
Robert Bosch GmbH
Checking / calibration | HTD 6xx / HTD 8xx | 57
11. Check whether the laser line of the laser visor is
parallel to the calibration triangle.
12. If the laser line is not parallel, loosen the holder for the
laser visor on both sides and turn the adjustment screw
until the alignment is correct.
en
|
1 692 106 011 2019-03-26