Luminous Intensity - Htd 8Xx - Bosch HTD 6 serie Serviceanleitung

2. Check if the green laser line runs through the center
point of the pendulum (Fig. 17). If necessary, adjust
the vertical by means of the adjusting screw on the
balance weight.
4
Fig. 17: Checking the pendulum's vertical
1 Reflection table
2 Rotation center
3 Counterweight
4 Adjusting screw
5 Green, vertical laser line
3. After successful adjustment, cover adjusting screw
with tape.
Robert Bosch GmbH
Checking / calibration | HTD 6xx / HTD 8xx | 65
4.6
1. Position the beam setter in front of the calibration
i
1
2
3
5
2. Check the position of the spirit level in the light box.
Luminous intensity – HTD 8xx
device.
The distance should be 20 - 30 cm.
In the event of deviation from the center position,
perform any necessary adjustment with the screws on
the trolley.
en
|
1 692 106 011 2019-03-26