Inhaltsverzeichnis
Werbung
Replacing the Movable Cutting
Blade
A spare movable cutting blade is located in the
accessory box. Replace the blade when it
becomes dull or nicked.
Unplug the machine.
Open front cover.
Set the movable cutting blade
a
in its engaged
position. Remove the movable cutting blade
by loosening the screw
with the
b
screwdriver
found in the accessory box.
c
Brush the fixed cutting blade and the
surrounding area to clean out any
accumulation of lint, etc.
Turn the flywheel to lower the movable
cutting blade holder to its lowest position.
At this position, put a new blade in place,
making sure that the edge of the blade
is approximately 0.5 to 1.0 mm below
the surface of the fixed cutting blade
d
. Tighten the screw
firmly.
b
NOTE: The fixed cutting blade is made of a
special hard alloy and will not normally have to
be replaced.
Replacing the Light Bulb
Unplug the machine.
Raise the presser foot and remove
lamp cover.
Unscrew the bulb and replace with new 15
watt bulb.
Reattach the lamp cover.
71
Werbung
Inhaltsverzeichnis
