Replacing The Bobbin Holder; Replacing The Light Bulb - ELNA 2600 Bedienungsanleitung

Replacing the Bobbin Holder

Insert the bobbin holder into the hook race.
1
Make sure the knob of the bobbin holder fits next to
2
the stopper on the race.
Knob
1
Stopper
2
Replace the bobbin.
3
Attach the needle plate, inserting the two guide pins
into the holes in the needle plate. Tighten the screw
firmly with the screwdriver.
Guide holes
3
Screw
4
Clean the machin with a soft cloth. Do not use chemical
solvent.
Store the machine in cool and dry place.
Do not store the machine in an area of high humidity,
near a radiator or in direct sunlight.

Replacing the Light Bulb

WARNING:
When replacing the bulb, switch off and unplug the
machine.
Wait for the light bulb to cool down before touching it.
Remove the cap and screw. Remove the face plate.
Cap
1
Screw
2
Face plate
3
Push and turn the bulb counterclockwise to remove it.
Push and turn the bulb clockwise to replace it.
Light bulb
4
90