Renishaw SP25M Bedienungsanleitung Seite 41

SP25M user's guide
http://www.renishaw.com
Pick up routines
Pick up routine - SM25 scanning modules and TM25-20 adaptor module
Move description
Clearance position
Enter port
Towards module
Attach module(s)
Exit port
To ensure optimum metrology performance it is recommended that following any module change the probe head is unlocked and then
relocked.
Pick up routine - SH25 stylus holders
Move description
Clearance position
Enter port
Towards stylus holder(s)
Attach stylus holder(s)
Exit port
Pick up routine - TP20 module
Move description
Clearance position
Enter port
Towards TP20 module
Attach TP20 module(s)
Exit port
* Coordinates assume aligned with Y-axis as per
** Calculate nominal 'Z' docking position according to the stylus length used (see calculation formula in section
position for SH25 stylus holders).
Issued 10 2015
X -axis (mm)*
[dat_MOD_port(n)]
no change
no change
no change
no change
X-axis (mm)*
[dat_SH_port(n)]
no change
no change
no change
no change
X-axis (mm)*
[dat_TP20_port(n)]
no change
no change
no change
no change
FCR25 mounting instructions
Y-axis (mm)*
[dat_MOD_port(n)] - 30 mm
[dat_MOD_port(n)]
no change
no change
[dat_MOD_port(n)] - 30 mm
Y-axis (mm)*
[dat_SH_port(n)] - 30 mm
[dat_SH_port(n)]
[dat_SH_port(n)]
[dat_SH_port(n)]
[dat_MOD_port(n)] - 30 mm
Y-axis (mm)*
[dat_TP20_port(n)] - 30 mm
[dat_TP20_port(n)]
[dat_TP20_port(n)]
[dat_TP20_port(n)]
[dat_TP20_port(n)] - 30 mm
Z-axis (mm)*
[dat_MOD_port(n)] + 8 mm
no change
[dat_MOD_port(n)] + 3 mm
[dat_MOD_port(n)]
no change
Z-axis (mm)*
[dat_SH_port(n)] + 8 mm
no change
[dat_SH_port(n)] + 3 mm
[dat_SH_port(n)]
no change
Z-axis (mm)*
** [dat_TP20_port(n)] + 6 mm
no change
**[dat_MOD_port(n)] + 3 mm
**[dat_MOD_port(n)]
no change
Establishing the docking
41