Renishaw SP25M Bedienungsanleitung Seite 11

SP25M user's guide
http://www.renishaw.com
Introduction
NOTE: Before unpacking and installing the SP25M probe system, please read the safety information and ensure that they are
followed at all times during system installation and operation.
This document is intended to provide help and guidance during initial installation, integration and subsequent use of the of the SP25M
probe system. It is assumed that the system will be installed on a coordinate measuring machine using a controller system that has had full
SP25M system integration in the form of a dedicated Renishaw controller or an AC3 (ISA bus) analogue interface PC card.
SP25M is a compact and versatile probe system that provides both scanning capability for form measurement or reverse engineering and
touch-trigger probing for geometric size and position measurement.
The SP25M system provides highly accurate scanning measurement with stylus lengths from 20 mm to 400 mm as well as full TP20 touch-
trigger probe module compatibility to suit a range of applications.
The SP25M system uses the Renishaw autojoint to enable repeatable mounting to the PH10M PLUS, PH10MQ PLUS and PH6M probe
heads. Multiwired extension bar mounting of the SP25M system is also possible to extend the reach and enable more access to part
features.
The range of SM25 scanning modules are designed to cover specific stylus length ranges whilst maintaining excellent accuracy
performance. The system can be readily expanded to further increase the scanning range, allow TP20 touch-trigger measurement or utilise
an automatic changer system.
Issued 10 2015
11