Renishaw SP25M Bedienungsanleitung Seite 140

SP25M user's guide
http://www.renishaw.com
WARNINGS: The use of eye protection is recommended.
Pinch hazards exist between parts and between moving and static parts. Beware of unexpected movement. You should remain
outside the full working envelope of probe head/extension bar/probe combinations.
It is the machine supplier's responsibility to ensure that the user is made aware of any hazards involved in operation, including those
mentioned in Renishaw product documentation, and to ensure that adequate guards and safety interlocks are provided.
Under certain circumstances, the probe signal may falsely indicate a probe seated condition. Do not rely on probe signals to stop the
machine.
NOTES: Renishaw recommends that datuming of the MCR20 is performed using the Renishaw PS2R stylus supplied. If a different
stylus is to be used, the length (L) must be either 20 mm or 30 mm and the appropriate ball radius (R) must be used to calculate
offsets.
It is strongly recommended that the EM1 STD and EM2 STD probe extension modules are not used for datuming of the MCR20, as
the extended probe length may lead to increased concentricity errors within the probe system.
The following instructions assume that uncompensated probing points are taken, and therefore that the target positions for port
docking are absolute machine co-ordinates.
Dimensions:
Length
Width
Height
Port entry velocity
Mounting orientation
Y-axis overtravel
Z-axis overtravel
Inhibit range
Issued 10 2015
200 mm
60 mm
145 mm
Maximum 800 mm/s
Not designed for horizontal operation with the ports in a vertical orientation
Hinged breakout from base
55 mm travel at port height
Hinged docking port assembly
90° travel in –Z axis
100 mm from port centre
140