Operation - Abicor Binzel iCAT Betriebsanleitung

7 Operation

7 Operation
NOTICE
• The device may only be operated by qualified personnel
(in Germany see TRBS 1203).
• Observe also the operating instructions of the welding components.
Due to the fact that the iCAT is integrated into the welding process of the torch, the operating
steps are performed after the respective torch has been put into operation. Please observe the
operating instructions of the respective ABIROB
welding torches.
8 Putting out of operation
NOTICE
• Please make sure that the shutdown procedures for all components mounted in the
welding system are strictly observed before putting out of operation begins.
Putting out of operation depends on the respective welding torch.
Please observe the operating instructions of the respective ABIROB
®
ABIROB W, ROBO WH welding torches.
9 Maintenance and cleaning
Regular and lasting maintenance and cleaning are the prerequisite of a long life and a trouble
free operation.
DANGER
Risk of injury due to unexpected start-up.
The following instructions must be adhered to for the entire duration of maintenance,
servicing, mounting, dismounting and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Disconnect all electrical connections.
DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
EN - 26
® ®
A, ABIROB GC, ABIROB
®
A, ABIROB
BAL.0139 • 2018-06-21
iCAT
®
W, ROBO WH
®
GC,