Abicor Binzel iCAT Betriebsanleitung Seite 66

9 Maintenance and cleaning
6 Clean the iCAT ABIROB
7 Grease the O-rings (6), (5) with sealing grease (included in the scope of delivery).
8 Mount the O-rings (6), (5) onto the compression sleeves (7).
9 Mount the balls (9), compression springs (8) and compression sleeves (7).
10Dismount the set screw (3) and gas duct (2) and check them, if necessary replace them.
11 Reinstall the fastening screw (12), washer (11) and screw (10).
12 Mount bellows (14) and retaining ring (13).
9.3 Cleaning the iCAT ABIROB
1
1 Retaining ring
2 Bellows
Fig. 17 Cleaning the iCAT ABIROB
WARNING
Risk of injury
Serious injuries caused by parts swirling around.
• When cleaning with compressed air, wear suitable protective clothing, in particular safety
goggles.
1 Clean the iCAT ABIROB
2 Pull off retaining ring (1) and bellows (2) and clean with compressed air.
3 Remove screw (5), washer (6) and fastening screw (4) and clean them together with
compressed air.
EN - 30
®
W (4) with compressed air.
®
GC
2
6
®
3 iCAT ABIROB GC
4 Fastening screw
®
GC
®
GC (3) with compressed air.
3
4
5
5 Screw
6 Washer
BAL.0139 • 2018-06-21
iCAT