Abicor Binzel iCAT Betriebsanleitung Seite 61

iCAT
6.9 Attaching the ROBO WH torch neck
1
1 ROBO WH torch neck
2 Hand lever
Fig. 14 Attaching the ROBO WH torch neck
NOTICE
• Do not change the hand lever position during the change procedure! This will result in
malfunctions. The open knife will cause the pre-tensioned welding wire to expand and to
become cut off when actuated next. These wire pieces will block the locking mechanism
and inevitably lead to failures of the entire system!
1 Insert hand lever (2) through the sealing lips of the clamp clip (4).
2 Move hand lever (2) forward toward the torch neck (1) through the pressure point as far as
it will go.
3 Insert torch neck into changeable body as far as it will go.
4 Move hand lever (2) rearward through the pressure point as far as it will go and take it after
locking.
BAL.0139 • 2018-06-21
5
3 iCAT ROBO WH
4 Clamp clip (in changeable body)
6 Putting into operation
2
3
4
5 Changeable body
EN - 25