The walls of the furnace is mounted must be heat resistant. In particular the side walls
were made of fiberboard coated. The coating resistant must be to 100 °C. This not
heat-resistant synthetic laminates and adhesives, plastics or adhesive materials may
be damaged. This information will only be to create a guide and the real resistance
against the increase in temperature depends on the degree of kitchen units and
surface polish performance.
Certain kitchen unit of surface of polishing types (example vinyl) is especially sensitive
at the lower temperatures with color damage, above mentioned temperatures.
Installation of the device in contravention of the warnings or the cabin materials
placed to device closer to the 5 mm responsibility of the owner.
The power cord avoid crush, fold and clamped or avoid contact with hot parts of
product. After installation, the plug must be easily accessible location.
There must be safe distance between kitchen walls and furniture.
A correct installation will have to ensure a proper protection against contact with
electric parts or merely functionally isolated parts.
All the units meant to ensure protection have to be fitted not to be taken away without
using a tool.
For the most efficient air circulation, the oven should be fitted according to the
dimensions shown in (See Figure 1 and Figure 2 )
If the built-in oven is mounted below the hob, distance of at least must be 50 mm.
The rear panel of the cabinet must be removed so that air circulates freely. The panel
to which oven is fitted should have a gap at least 75 mm at the rear. (See Figure 3)
We recommend not installing the appliance near refrigerators or freezer, since the
heat could affect the performance of these appliances.
Figure 1
7