General Overview; Manual Cooking; Setting The Minute Minder - Pyramis 201045 Installations- Und Gebrauchsanleitung

GENERAL OVERVIEW

TIME OF DAY SETTING
After plugging in or reconnecting to a power source after current decay, "0.00", and
"AUTO" flashes.
• Press button 1 approximately 2 sec., dot icon starts flashing. Set the current time
using buttons 2 and 3. About 7 seconds after the set time has been finished, new
data is memorized.
The time correction can be done later;
• Press button 2 and 3 approximately 2 sec., dot icon starts flashing. Then you can
set the current time.
Notice! If the correct time is not set then proper opera tion of the oven is not possible.

MANUAL COOKING

Without any cooking program, it is a cooking done by heat values setting and user-defined
function.

SETTING THE MINUTE MINDER

You can activate the minute minder at any time, regard less the activity state of other
programmer functions. The measured time ranges from 1 minute to 23 hours 59 minutes.
• Press button 1 until the minute minder icon starts to flash, and the display shows
"0.00".
• Enter the required time using buttons 3 and 2. Minute minder icon remains on the display.
After the set time has elapsed, an audible signal will be heard for approximately 7
minutes and the minute minder icon starts to flash again.
• Press buttons 1, 2 or 3 to turn the signal off; the minute minder icon disappears, and
the display indicates the current time.
CHANGE THE TIMER BEEPS
The tone of the timer beeps may be changed as follows:
Press buttons 2 and 3 simultaneously,
• Press button 1 to see actual tone "ton.1" to see on the display.
• Press button 2 to select the tone you wish from 1 to 3.
Figure 10
23