Pyramis 201045 Installations- Und Gebrauchsanleitung Seite 42

OVEN SEALING
Your oven has a sealing surrounding the inside edges which provides the oven to work properly.
 Check the state of the sealing periodically. If cleaning is necessary, avoid using
abrasives, corrosive detergents, bleaches or acids.
 If the sealing is damaged, consult with your nearest authorized service provider in
your area. Do not use the oven until it is fixed.
 The changing procedure of the oven seal is as follows;
1. Open the oven door,
2. Remove the old sealing by pulling out the seal from corners one by one as shown
in (See Figure 13),
3. Four hooks are attached to the seal. Use these hooks to attach and then press in
the new seal.
SIDE RACKS *
It is possible to easily remove and clean the wire shelving placed in the wire grid and tray.
You can recover the wire shelving from screw channel by stretch down the edge of special
plug, like as shown. Then, you can recover with pull up to outward and lift up to from upper
tabs. Install after cleaning; process done in reverse order, first the upper tabs set to boiler
rack, after that placed in a screw channel with stretching the special screw-earth channel
wings. (See Figure 14)
* Only available on some models.
Figure 13
Figure 14
42