Error Indications - Pyramis 201045 Installations- Und Gebrauchsanleitung

the screen by tapping the left until it starts to blink.
seconds, then stops blinking. 7 minutes during the set time is reached, the alarm sounds.
The alarm can be stopped
Alarm Clock:
In standby mode (when cooking something related)
the screen by tapping the left until it starts to blink.
7 seconds, then stops blinking. The set time is reached, the alarm starts sounding. The
alarm can be stopped

ERROR INDICATIONS

When situations which prevent normal operation occur, the device enters error
mode. Device is in the standby status but an error code is displayed on Time of Day
Display. Even if the error recovers, this code will remain on the display until
touched. A total number of 8 error codes exist:
Error
Code Error Definition and possible causes
Communication error between UM and PM boards
Err1
DKB2-XX-POC400 data cable connector may be loose on either side
DKB2-XX-POC400 data cable may be defect
POC 400 PM may be defect
Oven Cavity Temperature Sensor Open Circuit
Err2
PT–1000-M2-XXX sensor connector may be loose on the PM
PT–1000-M2-XXX sensor may be defect
POC 400 PM may be defect
Oven Cavity Temperature Sensor Open Circuit
Err3
PT–1000-M2-XXX sensor may be defect
POC 400 PM may be defect
Front Panel Temperature Limit Exceeded
Err4
The Temperature of the UM exceeded limit (100 ºC) , check cooling fan
POC 400 UM may be defect
PM Temperature Limit Exceeded
Err5
The Temperature of the PM exceeded limit (105 ºC) .
POC 400 PM may be defect
UM heat sensor error
Err6
POC 400 UM may be defect.
PM heat sensor error
Err7
POC 400 PM may be defect.
No Temperature Regulation
Err8
Check heating elements and connections
POC 400 PM may be defect
In case of an Error Message:
If those errors cannot be recovered by touching the
from mains power and connecting again after 2 minutes may correct the errors.
PROGRAMMABLE OPTIONS
or tapping the keys.
or tapping the keys.
Page 6 / 8
35
or keys to set the time using. 7
key twice to touch the icon
or keys to set the time using.
button, disconnecting the oven
on
key is