Pyramis 201045 Installations- Und Gebrauchsanleitung Seite 12

 Connection must comply with national regulations.
 The oven must be positioned for that easy access to wall outlet or a duble pole switch
for electrical connection.
 Do not position the Power supply cord to contact hot surfaces.
 When the Power supply cord is damaged, consult your nearest authorized service location,
and Table 1, provide to change with the appropriate to feature of original spare parts.
 If the device is connected directly to the device with the electrical wiring system shall
be installed between the two poles of a circuit breaker and the earthing cable must
not be interrupted by a two-pole circuit breaker.
 The adapters, multiple sockets or extension cords are not recommended for use.
In accordance with applicable safety laws must be necessary to use an adapter or
extension cord. However, certainly for the adapter and power should not exceed the
specified maximum current capacity.
 After the connection is finished, be sure to test the heating elements up to 3 minutes.
 The electrical safety of the appliance can only be guaranteed when it has been
correctly connected to an efficient earthed power supply, as laid down in the
regulations for electrical safety. The manufacturer can not be held responsible for any
damage to persons, animals or things due to the lack of an earth connection.
Information for authorized experts (combi oven):
 Instructions regarding different connection methods are located on the rear panel of
the device next to the terminal box of the oven.
 Before connecting the device, make sure the local voltage matches the specifications
on the rating label.
 Make sure to connect the protective ground to the terminal of the marked terminal
block. The electric connection of the oven should incorporate an emergency switch for
disconnecting the entire device from the mains in case of an emergency. The distance
between the normally open contacts of the emergency switch must be of at least 3 mm.
 The device is suitable for three-phase and AC current (400V 3N~50Hz).
 The heating elements have a nominal voltage of 230V. The device can be adjusted
for single-phase current (230V) by a respective bypass on the terminal block, based
on the circuit diagram below. Select a suitable cord as mains cable, considering the
connection type and nominal power of the oven.
Figure 5
12