Cleaning And Care; Disposal - Silvercrest SBF 75 Bedienungs- Und Sicherheitshinweise

Troubleshooting / Cleaning and Care / Disposal
= Assign the unknown value in the app or reas-
sign user.
= The LC-display
1
= The fat percentage is outside the measurable
range (less than 3 % or higher than 65 %).
= Repeat the measurement barefoot, if neces-
sary dampen the bottoms of your feet.
= The LC-display
1
= The maximum load capacity of
180 kg / 396lb / 28 st has been exceeded.
= Do not exceed 180 kg/396lb/28 st.
= „Err" or incorrect weight appears.
= The surface is not level or firm.
= Place the scales on a level, firm surface.
= You are not standing still.
= Stand as still as possible.
= The incorrect weight appears.
= The zero point of the scales is incorrect.
= Wait for the diagnostic scales to shut off auto-
matically. Activate the diagnostic scales, wait
for „0.0 kg" to appear, then repeat the meas-
urement.
= No Bluetooth connection (
®
appear).
= Device out of range.
= The open area minimum range is approx. 10 m.
Walls and ceiling reduce this range. Other
radio waves can interfere with transmission.
Therefore do not place the diagnostic scales
near devices such as WiFi router, microwave,
induction hobs.
= No Bluetooth connection (no
®
= Not connected to the app.
= Completely close the app (including in the
background).
Restart Bluetooth .
®
Restart the smartphone.
Briefly remove and reinsert the batteries in the
scales.
16 GB/CY
is scrolling „- - - -".
reads „Err".
does not
16
symbol).
= The LC-display reads „Full".
1
= The user memory is full. No additional
measurements will be saved.
= Open the app within Bluetooth
The data will automatically be transferred. This
may take up to a minute.
= The LC-display reads „Lo".
1
= The batteries in the diagnostic scales are
dead.
= Replace the batteries.

Cleaning and Care

Do not clean with chemical cleaners or scour-
ing agents.
Clean the product with a damp cloth. For more
stubborn dirt you may also apply a weak soap
solution to the cloth.
Never immerse the product in water or other
liquids. The devices may otherwise be damaged.
Ensure water does not enter the product. If this
does occur, wait for the devices to dry com-
pletely before using it again.

Disposal

The packaging is made entirely of recy-
clable materials, which you may dispose
of at local recycling facilities.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and fibre-
board / 80–98: composite materials.
To help protect the environment, please
dispose of the product properly when it
has reached the end of its useful life and
not in the household waste. Information
on collection points and their opening
hours can be obtained from your local
authority.
range.
®