Changing The Batteries; Error Messages; Cleaning And Care - Silvercrest SDL 300 C2 Bedienungsanleitung

Changing the batteries

As soon as the battery becomes low, the " " symbol
will be shown on the display 2 to remind you to
replace the battery soon . When "
on the display 2, the battery is empty .
You should then replace the battery:
♦ Remove the cover of the battery compartment 5 .
♦ Take out the empty battery, and replace it with
a new 1 .5 V AAA/LR03 battery . Ensure that the
battery has the correct polarity .
♦ Close the battery compartment 5 .

Error messages

- "OUTZero": There is already more than 30 g
weight in the spoon 1 when the scale is switched
on . Remove the weight from the spoon 1 and then
switch the appliance back on again .
- „UNSTable": The appliance is not being held
stably/level while being switched on . Place the ap-
pliance on a stable support/hold the appliance level
and still in your hand .
– The batteries are low . The batteries will need to
be replaced soon!
– The batteries are dead . Replace the
batteries!
- Overload! The material in the spoon 1 is
heavier than the maximum allowed weight!
Remove some material from the spoon 1!

Cleaning and care

ATTENTION! PROPERTY DAMAGE!
Do not use abrasive or chemical cleaning
materials . These will damage the surface of the
appliance!
♦ Clean the appliance with a damp cloth . For
stubborn soiling use a mild detergent on the
cloth .
NOTE
You can remove the spoon 1 from the
spoon handle and clean it separately in
the dishwasher .
♦ Ensure that the appliance is properly dry before
re-using it .
│ GB │ MT
■ 44
" appears
SDL 300 C2