Changing The Battery; Measuring Jug Scale; Troubleshooting; Cleaning And Care - Silvercrest HG03301 Bedienungs- Und Sicherheitshinweise

If the foodstuff have been already
placed in the measuring jug 1 , the
letter T appears in the lower left corner
of the LC display 4 .
To display the weight of the foodstuff
item again, briefly press the on/off
switch /Z 5 again. The letter T goes
off.
If you remove the foodstuff item after
using the tare function, a negative value
is displayed. Briefly press the on/off
switch /Z 5 to reset the scale to 0.
m
CAUTION! Do not – especially
when using the tare function – exceed
the maximum permitted weighing
value. Otherwise, the product may be
damaged.
˜ Changing the battery
Replace the battery as soon as " Lo " is
displayed or if the product cannot be
switched on anymore.
Loosen the screw of the battery
compartment cover 8 , using a
screwdriver.
Remove the battery compartment
cover 8 .
Remove the used button cell.
Insert a new CR2032 button cell. The
positive pole (+) must point outwards.
Replace the battery compartment
cover 8 .
Secure the battery compartment
cover 8 with the previously loosened
screw.
˜ Measuring jug scale
Using both scales on the measuring jug 1 ,
the approximate amount of cups or the
volume in millilitres (ml) and fluid ounces
(fl'oz) can be read without switching the
12 GB/IE/NI
product on.
˜ Troubleshooting
If " Err " is displayed instead of a measured
value, the maximum permitted weighing
range has been exceeded. In this case,
immediately remove the foodstuff items
from the measuring jug 1 . Separate the
foodstuff into several portions and then
weigh the portions individually.
˜ Cleaning and care
For hygienic reasons, clean the product
after each use.
m
WARNING! Do not immerse the
electrical parts of the weighing unit 3
in water or other liquids. Never hold it
under running water.
Part Cleaning
Measuring 1 Clean in a dishwasher or
jug by hand under running
water (if needed, use a mild
detergent).
Weighing 3 Wipe with a slightly
unit moistened cloth.
Do not use abrasives, harsh cleaning
solutions or hard brushes for cleaning.
Let all parts dry afterwards.
˜ Storage
When not in use, store the product in its
original packaging.
Store the product in a dry, secure
location away from children.
˜ Disposal
The packaging is made entirely of
recyclable materials, which you may
dispose of at local recycling facilities.