Start-Up
Setting up device
Warning:
Risk of slipping device!
As a result of vibrations generated during operation the device might
slide off the table top.
The surface must be smooth and clean and should be properly
leveled.
➜ Locate the shaker on a stable, horizontal surface.
➜ Clean surface and feet with a damp cloth and ethanol regularly.
Connect/disconnect power cord
Connect power cord
The power cord comes with a three-wire
plug and a recess on the bottom side.
The socket is located on the back side of
the unit.
✓ The device is switched OFF.
➜ Connect plug to the socket with the
recess facing down.
➜ Push plug up against socket until
securely attached.
➜ Connect plug to power socket.
Disconnect power cord
➜ Disconnect plug from power socket first.
➜ Then disconnect plug from socket on unit.
Start-Up
Unit plug
Power cord
Unit socket
12
Start-Up
Switch unit on and off
The ON/OFF switch is situated on the front
panel.
Switch unit on
➜ Press the On/Off switch on the lower
side.
✓ The green control light switches on.
✓ The unit is switched on.
Switch unit off
➜ Press the On/Off switch at the upper
side.
✓ The green control light switches off.
✓ The unit is switched off.
Duomax 1030 / Polymax 1040
ON/OFF switch
Unit switched on
Unit switched off
13