Clamps For Separatory Funnel; Multi-Tier Attachment - Heidolph Hei-MIX Promax 2020 Originalbetriebsanleitung

Assembly
▪ 25 to 100 ml clamps feature one
threaded bolt.
▪ 250 - 1000 ml clamps feature four
threaded bolts.
➜ Remove nuts and washers from clamp
bolts.
➜ Plug clamp in rack hole.
➜ Secure with washer.
➜ Tighten nuts with box-end spanner.
➜ Ensure all screws have been pulled
tight.
The only restriction is to arrange clamps in
a manner avoiding direct contact between
each other; moreover, flasks should not
protrude over the edge of the shaker
plate.
➜ Locate perforated platform with clamps
installed on shaker plate.
➜ Make sure, crimped edge is plugged
over shaker plate, thus positively
locking both parts with each other.
Lightly tilt Erlenmeyer flasks to fit them under the clamp.

Clamps for separatory funnel

Perforated platform and separatory funnel clamp safely hold size 250 ml to 2000 ml
separating funnels on the shaker plate.
The perforated platform accepts the following number of separatory funnel clamps:
▪
4 ea. 250 ml
▪ 3 ea. 500 ml
▪ 3 ea. 1000 ml
▪ 2 ea. 2000 ml
A mix of various sizes may be used either.
Nuts Washers Clamp bolts
Washers Clamp bolts
Nuts
Crimped edge
20
Assembly
Caution
Risk of breakage
If clamps for separatory funnels are mounted too close, separatory
funnels could break when touching each other during operation.
Maintain sufficient space between separating funnels to avoid a
collision situation.
➜ Remove nuts and washers from side
bars B and C.
➜ Plug side bars B and C into the
perforated platform holes, so that
dimension „A" is about 25 mm less
than length „L" of the separatory
funnel.
✓ The distance should guarantee proper
clamping of the separatory funnel
and its closing plug by means of
compression spring.
✓ Dimension „A" once set will be good for
one and the same size of separatory
funnel only.
✓ Whenever using a different model
of separating funnel, you need to
check dimension „A" and readjust
accordingly.
➜ Install washer and nuts on bolts of side
bars B and C; pull tight with box-end
spanner from your hardware bag.
➜ Locate perforated platform with funnel clamps on shaker plate.
➜ Make sure, crimped edge is plugged over the shaker plate, so positively locking both
parts with each other
Install separatory funnel
➜ Install separating funnel with its outlet pipe first through compression spring.
➜ Press item against compression spring until closing plug locks with retainer ring.

Multi-tier attachment

At high loads (load-bearing capacity of shaker plate) and high
frequency of shaking, always make reference to load graph as appli-
cable for your item (see chapter „Technical data", section "Performance
range / permissable load").
The multi-tier attachment allows installation of a second or third rack plate for
Erlenmeyer flasks on the shaker plate.
▪ 25 ml Erlenmeyer flasks: allows a total of 3 perforated platforms
▪ 50 ml bis 250 ml Erlenmeyer flasks: allows a total of 2 perforated platforms
Closing plug
Compression
Retainer ring Outlet pipe
spring
Nut Box-end spanner Perforated
platform
Washers
B Side bars
21
C