Assembly; Electrical Connections; Mounting Attachments; Base Frame And Tension Rollers - Heidolph Hei-MIX Promax 2020 Originalbetriebsanleitung

Assembly

Assembly

Electrical connections


▪ Fuses must only be replaced by a professional electrician.
▪ Repairs to the device must only be carried out by a qualified electrician
approved by Heidolph Instruments. Improper repairs could result in serious
dangers. Please contact your specialist dealer if the device needs to be repaired.
Warning:
Risk of electric shock
The device must be connected to an earthed power socket.
The rated voltage for the device and the supply voltage must be the
same. The rated voltage for the device can be found on the rating plate
on the rear of the device.
The device is supplied with a grounded power cord. In case the original
plug is replaced, the new plug must have a protective conductor!
If the device is still connected to power while changing the fuse, you
might get in contact with live parts.
Prior to replacing the fuse ensure that the unit is switched off and pull
the plug from the electric socket. Only use original spare fuses from
Heidolph Instruments.
After changing a fuse check the device for safe operating condition
according to IEC 61010-1.
Unit socket
Rating plate
Color code for electrical connections:
Europe
GREEN/YEL- PE: Protective
LOW
conductor (Earth)
BLUE N: Neutral conductor
BROWN
P: Phase
The device is connected to the mains with the power cord supplied. The power connection
is located on the rear of the housing.
For countries where a different plug than the standard plug supplied is used:
▪ The plug supplied may only be changed by a professional electrician.
▪ If you wish to use an adapter, ensure that it is grounded and approved in accordance
with the local regulations.
▪ Wiring, adapter and plug must at least meet the electrical power stated on the rating
plate.
Fuse
North America
PE: Protective
GREEN
conductor (Earth)
WHITE N: Neutral conductor
BLACK
P: Phase
18
Assembly

Mounting attachments



Base frame and tension rollers

Base frame and tension rollers allow to
safely attach whatever sort of vessels and
racks on the shaker platform.
Components frame tension roller:
▪
4 bolts
▪ 1 box-end spanner
▪ 2 holding bars
Necessary on top:
▪ Min. 2 pcs tension rollers
➜ Thread 4 ea. bolts in the respective
holes of platform and pull tight with
box-end spanner from hardware bag.
➜ Slip holding bar over bolts and secure
with wing bolts.
➜ Slip tension rollers over holding bars,
push against the vessel to be clamped,
and secure with wing bolts.
➜ Attaching one more row of vessels
requires installation of extra tension
rollers.
➜ Lock tension rollers safely in place and
pull all screws of the universal mount
tight as specified.

Clamps for Erlenmeyer flasks

The perforated platform with appropriate
clamps allows to safely hold Erlenmeyer
flasks of even different sizes on the shaker
plate.
Distribution of holes in the rack permits
whatever combination of clamps.
✓ At the bottom of the perforated
platform a box-end spanner is attached
to mount clamps.
Bolts Holding bars Tension rollers
19