Wireless Remote Control; Setting The Pump; Factory Settings; Control Panel - Grundfos UPE 2000 Series Montage- Und Betriebsanleitung

6.12 Wireless remote control

For wireless operation and reading of data, use the
GRUNDFOS remote control R100.
For application of the remote control, see section
7.3 R100.

7. Setting the pump

For the setting of the pump, use:

• Control panel.

• R100 remote control.
• Bus communication (not described in detail in
these instructions. Contact GRUNDFOS).
The following table shows the application of the indi-
vidual operating units and in which section the func-
tion has been described.
Function
Proportional-pressure con-
trol
Constant-pressure control
Setting of pump head
Max. curve duty
Min. curve duty
Constant curve duty
Temperature influence
Resetting of fault indica-
tions
Activation/deactivation of
pump buttons
Allocation of pump number
Reading of various data
Start/stop
"-" = not available with this operating unit.

7.1 Factory settings

UPE xx-60
Proportional
Control mode
pressure
3 m at maximum
Head
flow, see fig. 13
7.2 Control panel
The control panel, fig. 11, incorporates the following:
• Buttons, "+" and "–", for setting.
• Light fields, yellow, for indication of control mode
and pump head.
• Indicator lights, green and red, for operating and
fault indication, see section 6.6 Indicator lights.
Fig. 11
Light fields
7.2.1 7.6.1
7.2.1 7.6.1
7.2.2 7.4.1
7.2.1 Setting of control mode
7.2.3 7.4.2
Description of function, see section 6.1 Control
7.2.4 7.4.2
modes.
- 7.4.2
When the buttons "+" and "–" are pressed simultane-
- 7.6.3
ously, the light fields will indicate the selected control
mode:
7.2.6 7.4.3
- 7.6.4
Top + bottom
- 7.6.5
light fields flashing
7.5.1 -
Middle light fields
-
7.5.7
7.2.5 7.4.2
None of the light
If the buttons are pressed for more than 5 sec., the
control mode will change over to constant pressure
and proportional pressure respectively. This means
UPE xx-120
that constant curve duty is deactivated if selected by
Proportional
means of the R100.
pressure
6 m at maximum
flow, see fig. 15
At high liquid temperatures, the pump may
be so hot that only the buttons should be
touched to avoid burns.
Buttons
Indicator lights
Light Fields Control mode
Proportional pressure
Constant pressure
flashing
Constant curve
fields are on
13