Start/Stop Of Pump; Remote Control R100 - Grundfos MAGNA UPE 2000 Series Montage- Und Betriebsanleitung

7.2.3 Setting to max. curve duty
Description of function, see section 6.5 Max. or min.
curve duty.
To change over to the max. curve of the pump, press
continuously until MAX illuminates, see fig. 23. To
change back, press continuously until the desired
setpoint is indicated.
Fig. 23
Max. curve
7.2.4 Setting to min. curve duty
Description of function, see section 6.5 Max. or min.
curve duty.
To change over to the min. curve of the pump, press
continuously until MIN illuminates, see fig. 24. To
change back, press continuously until the desired
setpoint is indicated.
Fig. 24
Min. curve

7.2.5 Start/stop of pump

Stop the pump by continuously pressing
STOP illuminates. When the pump is stopped, the
green indicator light will be flashing.
Start the pump by continuously pressing
Note: If the pump is to be inoperative for a period, it
is recommended to use the start/stop input, the R100
or to switch off the electricity supply. In this way, the
setpoint setting will remain unchanged when the
pump is to be started again.
7.2.6 Resetting of fault indications
The fault indications are reset by briefly pressing any
button. The settings remain unchanged. If the fault
has not disappeared, the fault indication will reap-
pear. The time until the fault reappears may vary
from 0 to 255 seconds.

7.3 Remote control R100

The pump is designed for wireless communication
with the GRUNDFOS remote control R100. The
R100 communicates with the pump via infra-red
light.
During communication, the R100 must be pointed at
the pump control panel. When the R100 is communi-
cating with the pump, the red indicator light will flash
rapidly.
The R100 offers additional possibilities of setting and
status displays for the pump.
until
.
17