Connecting The M-100Fx To Your Computer - Edirol M-100FX Bedienungsanleitung

Connecting the M-100FX to your computer

The M-100FX has a USB connector that lets you connect it to your personal
computer. If the M-100FX is connected to your computer via a USB cable, the
audio signal (sound) output from your computer can be mixed with the
audio signals that are being input into the M-100FX, or the signals (sounds)
mixed by the M-100FX can be sent to your computer.
The sounds mixed or processed by the M-100FX's effects can also be
recorded into music production software or waveform editing software on
your computer to create your own original audio data.
What is USB?
USB stands for Universal Serial Bus, and is an interface that lets you connect
a variety of peripheral devices to your computer. A single USB cable can
connect many different kinds of devices, and convey data at high speed.
You can also connect or disconnect peripheral devices without having to
turn off the power first, and your computer will automatically detect the
device that you connected. Some devices may require you to make settings
or perform other procedures.
You computer will detect the M-100FX as a device used to transfer audio
signals to and from the computer.
* The M-100FX supports USB Version 1.1.
In order to use the M-100FX via its USB connector, you must install a driver
in your computer. For details on installing the driver, refer to Connecting
the M-100FX to your computer (p. 124).
Install the driver as described in Connecting the M-100FX to your
computer (p. 124).
To record audio into your computer, make connections as shown in the
diagram below.
Connect the USB cable to the USB connector on the back of the M-100FX. For
details on connecting your monitor speakers or headphones, refer to
Connecting monitor speakers or headphones (p. 19).
fig.pc1
USB cable
Personal computer
Basic operation
If you are using Windows
and want to send the
playback of an audio CD to
the M-100FX via USB, you
will need to use Windows
Media Player 7 or later. If
you are using Advanced
mode on Mac OS9, you
cannot send the playback
audio from a music CD to
the M-100FX.
For details on connecting a
mic to input your voice,
refer to Connecting a mic
(p. 20).
25