Windows Xp/2000 Users - Edirol M-100FX Bedienungsanleitung

Windows XP/2000 users

1.
With the M-100FX disconnected, start up Windows.
Disconnect all USB cables except for a USB keyboard and USB mouse
(if used).
2.
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to exit it as well.
3.
Place the M-100FX's ADVANCE (mode select) switch in the OFF position.
fig.advance-off
Advanced mode is off
4.
Use the USB cable to connect the M-100FX to your computer.
1. With the power switch turned OFF, connect the AC adaptor to the
M-100FX.
2. Connect the AC adaptor to an electrical outlet.
3. Use the USB cable to connect the M-100FX to your computer.
5.
Lower the M-100FX's master fader to the minimum position, and turn ON
the power switch.
The M-100FX will be detected automatically, and the driver will be installed.
6.
When installation is complete, restart Windows.
Next, you will need to make the driver settings.
(→Settings and checking (p. 131))
Connecting the M-100FX to your computer
Once the connections have
been completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong order,
you risk causing
malfunction and/or
damage to speakers and
other devices.
Always make sure to have
the volume level turned
down before switching on
power. Even with the
volume all the way down,
you may still hear some
sound when the power is
switched on, but this is
normal, and does not
indicate a malfunction.
If you are using Windows
XP, the installation has
been completed when the
message near the taskbar
saying that "Found New
Hardware" has
disappeared.
125