Installing The Special Driver (Macintosh) - Edirol M-100FX Bedienungsanleitung

Using Advance mode
Installing the special driver
(Macintosh)
This driver cannot be used in Mac OS X. If you are using a
Macintosh in which Mac OS X is installed, you must start up
using Mac OS 9, install the driver, and use it in Mac OS 9.
You cannot use this driver in the Classic environment.
■ Installing the audio driver
1.
With the M-100FX disconnected, start up Macintosh.
Disconnect all USB cables except for a USB keyboard and
USB mouse (if used).
2.
Exit all currently running software (applications).
Also close any open windows. If you are using virus
checking or similar software, be sure to exit it as well.
3.
Insert the CD-ROM into the CD-ROM drive of your
Macintosh.
4.
Double-click the M-100FX Driver-E Installer icon (found
in the Driver E (Mac OS 9) folder of the CD-ROM).
5.
Verify the installation location, and click [Install].
The location for installation will depend on your system.
Make sure that the startup disk for the system you are
currently using is selected.
6.
If a message like "This installation requires your
computer to restart after installing this software —".
is displayed, click [Continue].
The other currently running applications will exit, and
installation will continue.
7.
A dialog box will indicate Installation completed. Click
[Restart] to restart your Macintosh.
8.
Place the M-100FX's ADVANCE (mode select) switch in
the ON position.
9.
With the power switch turned OFF, connect the AC
adaptor to the M-100FX.
10.
Connect the AC adaptor to an electrical outlet.
11.
Use the USB cable to connect the M-100FX to your
computer.
12.
Set the M-100FX's power switch to the ON position.
168
■ Installing the ASIO driver
The M-100FX supports ASIO 1.0 24-bit audio.
The ASIO driver of the M-100FX supports the following
audio input/output channels.
• Audio input .......24/16 bit 1 stereo ch. (2 monaural chs.)
• Audio output .....24/16 bit 1 stereo ch. (2 monaural chs.)
In Advanced mode, the M-100FX cannot play back audio
data from the Macintosh's sound manager (such as audio
CDs and alert sounds).
This section explains how to install the ASIO driver that
allows the M-100FX to be used by your sequencer
software or audio editing software.
1.
From the Driver E (Mac OS 9) - ASIO folder of the
CD-ROM, copy M-100FX ASIO1.0 24bit to the ASIO
Drivers folder within the folder of the ASIO-compatible
software you are using (e.g., Cubase VST, Logic Audio,
Digital Performer, Metro, or SPARK LE).
2.
Start up your ASIO-compatible software (e.g., Cubase
VST, Logic Audio, Digital Performer, Metro, or SPARK
LE).
3.
Open the Audio setting dialog box of your ASIO-
compatible software, and select M-100FX ASIO1.0 24bit
as the ASIO Device.
The Audio setting dialog box will be named differently
depending on your software. For details refer to the
manual of your software.
An M-100FX ASIO 1.0 16-bit driver is also included. If you
are using software that does not support 24-bit audio, use
M-100FX ASIO 1.0 16-bit.