Adjusting The Gain And Level (Volume) - Edirol M-100FX Bedienungsanleitung

Basic operation

■ Adjusting the gain and level (volume)

After you have made connections, use the following procedure to adjust the
volume appropriately.
1.
Lower the input level knob (GAIN), master volume fader,
monitor volume knob, and headphone volume knob to
their minimum positions.
2.
Adjust the gain.
While speaking/singing/performing into the mic, turn the input level knob
toward the right for the channel to which your mic is connected. Adjust the
input volume so it is as high as you can get it without causing the peak
indicator to light.
fig.mic1
3.
Set the master volume fader to the center of the area shown in
the panel illustration below.
fig.mic2
4.
Adjust the input level.
Adjust the input level fader so that the yellow LED (0 dB) of the master
volume indicator lights occasionally.
If you are simultaneously recording with more than one mic, slowly raise
the input level faders of all input channels to adjust their levels.
fig.mic3
22
Set the fader
in this area
Yellow LED
blinks
The peak indicator will
light when the input signal
level (volume) is excessive,
indicating that the input
signal is distorting.
To obtain the best audio
quality, you should set the
input level as high as
possible; i.e., raise the gain
as high as possible without
allowing the peak indicator
to light.