Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Names of things and what they do
36 ...Ground terminal
In some cases, depending on the environment in which the unit is installed, the surface of the panel
may sometimes feel rough and grainy. This is due to an infinitesimal electrical charge, which is
absolutely harmless. However, if you are concerned about this, connect the ground terminal (see
figure) with an external ground. When the unit is grounded, a slight hum may occur, depending
on the particulars of your installation. If you are unsure of the connection method, contact the
nearest Roland Service Center, or an authorized Roland distributor, as listed on the "Information"
page.
Unsuitable places for connection
• Water pipes (may result in shock or electrocution)
• Gas pipes (may result in fire or explosion)
• Telephone-line ground or lightning rod (may be dangerous in the event
of lightning)
37 ...Security Slot (
http://www.kensington.com/
Block diagram
The following diagram shows the signal flow within the M-100FX.
fig.block
M-100FX BLOCK DIAGRAM
MONO INPUTS
GAIN
MIC1
GAIN
MIC2
STEREO INPUTS
LINE3/4
LINE5/6
EQ
LEFT
EQ
RIGHT
LINE7/8 LINE9/10
LEFT
EQ
RIGHT
EQ
STEREO AUX RETURN
LEFT
RIGHT
18
)
AUDIO/
VOICE
EFFECTS
PAN
FX SW
EQ
PAN
FX SW
EQ
LEVEL
BALANCE
LEVEL
BALANCE
AUX RETURN LEVEL
USB MIX DOWN SW
USB AUDIO IN LEVEL
MASTER BUS
LEFT RIGHT
AUX
USB BUS
L / R
SEND
SEND
SEND
SEND
REVERB
(internal)
AUX
PHONES LEVEL
MONITOR OUT LEVEL
LEFT
RIGHT
MASTER OUT LEVEL
LEFT
RIGHT
LEFT
RIGHT
MASTER OUT LEVEL
LEFT
RIGHT
AUX SEND
PHONES
MONITOR OUT
LEFT
RIGHT
MASTER OUT
LEFT
RIGHT
DIGITAL OUT
USB AUDIO
OUT
IN
Werbung
Inhaltsverzeichnis
