Edirol M-100FX Bedienungsanleitung Seite 14

Names of things and what they do
fig.panel2
12 ...Effect switches (FX)
These switches select whether the audio/voice effect will be on (effect applied) or off (effect not
applied). The switch will light in red when on. If the effect switches of both CH 1 and 2 are on,
the Stereo Control feature will be activated. (→Stereo Control (p. 111))
What is an effect?
An "effect" is a type of processing that modifies or transforms the sound in a special way,
sometimes giving it an entirely different character.
13 ...Equalizer knobs (HI/LO)
These knobs adjust the tone. HI adjusts the high-frequency range (10 kHz), and LO adjusts the low-
frequency range (200 Hz).
14 ...Reverb/AUX send level knobs (REV/AUX SEND)
These knobs adjust the level of the signal that is sent to the internal reverb and the external output
jack. If you are using the internal reverb, use the reverb/AUX send level knobs to adjust the depth
of reverb.
15 ...Pan/balance knobs (PAN/BALANCE)
These knobs adjust the left/right balance of the sound that is sent to the master output jacks.
For CH 1 and 2, these knobs adjust the pan. When converting a monaural input signal into stereo,
they adjust the left/right balance (pan).
For CH 3/4–9/10, these knobs adjust the balance. They adjust the left/right balance of the stereo
audio input signal.
* If sound is being input only to the L channel of CH 3/4–9/10 and you turn the pan/balance knob all
the way to the R (right) position, you will not hear any of the input sound.
16 ...Input level faders
These faders adjust the volume of each input channel.
14
12
13
14
15
16