Rear Panel; Usb Connector - Edirol M-100FX Bedienungsanleitung

Rear panel

fig.rear
30
31
30 ...Power switch
Press this switch to turn the power on/off. The power is on when this switch is in the inward
position.
31 ...AC adaptor jack
This is the power supply jack. Connect the included AC adaptor here.
32 ...ADVANCE (mode select) switch
This switches the operating mode when the M-100FX is connected to your computer via a USB
cable. Normally, you will leave this in the OFF position.
You cannot change the setting of this switch while the M-100FX is operating.
After you change the setting, you must turn the power of the M-100FX off, then on again.
* Some music production and audio editing software uses more sophisticated software (such as WDM or
ASIO) to transfer audio data between the computer and peripheral devices. If you are using this type of
software, you must put the M-100FX in Advanced mode and install the special driver. If the M-100FX's
ADVANCE switch is in the ON position, it will be in Advanced mode. For details on installing the
special driver, refer to Using Advance mode (p. 163).
33 ...USB mix down switch
This switch selects whether audio signals sent from your computer via USB to the M-100FX will be
returned to the computer. Normally, you will leave this in the OFF position.
* If this is ON, the same sound that is being output from the master output jacks will be sent to the USB
connector. If this is OFF, the sound that is being output from the master output jacks minus the sound
that is input from the USB connector will be sent to the USB connector.

34 ...USB connector

Use a USB cable connected here to connect the M-100FX to your computer.
35 ...Digital output jacks
These jacks send the digital audio signal from the M-100FX to an external digital audio device.
Use these jacks if you want to digitally connect the M-100FX to a digital audio device such as an
MD or DAT recorder. You can also connect these connectors to amplified speakers that have digital
input jacks.
OPTICAL
COAXIAL
* The digital output jacks output the same signal as the master output jacks.
32 34
33 35
Use an optical digital cable to make connections
Use a coaxial cable to make connections
Names of things and what they do
36
37
17