Simultaneous Washing - Faema Emblema Gebrauch Und Installation

SIMULTANEOUS WASHING

1
Remove the filter holder
from the coffee group.
4
Con rm the washing mode
using the key ; the screen
will display:
INSERT. FILTER HOLDER
push
INSERT. FILTER HOLDER
to con rm
8
Press the coffee circuit wash
key (26).
12
Press the coffee circuit wash
key (26).
2
Using a brush, clean the
cover gasket.
5
Insert the rubber disk into
the lter-holder with its lter.
9
The wash cycle will start and
the GR WASH message
will appear in alternated way
on the display.
GR... WASH
13
The message "GR RINSE"
will appear in alternated way
on the display.
GR... RINSE
3
to change sel.
to con rm
6
Pour in a packet or dosing
cupful of detergent powder.
10
At the end of wash cycle,
the message "REMOVE
GROUP FILTER HOLDER"
will appear.
REMOVE GROUP
FILTER HOLDER
14
T h e w a s h i n g c y c l e i s
complete after the rinsing
phase.
11 October 2013
15:40:51
23 EN
Hold down the coffee circuit
washing key (26) for a few
seconds.
The simultaneous washing
screen (preset mode) will
appear on the display.
7
Hook all the lter holders to
the groups.
11
Remove the lter holders.
Do not remove the lter holder
during coffee dispensing.