Key Menu - Steam And Air Selection; Banner - Faema Emblema Gebrauch Und Installation

23. Key menu - Steam and air selection

Select the position of the "steam selector lever" (11) and
press the "AUTOSTEAM automatic steam key" (12a)
. The following will appear on the display:
KEY MENU
Type Steam and air TS..
The following parameters can be modi ed:
- T stop steam ("xxx°C" temperature for hot milk or frothed
milk).
Setting options:
"0°" (0°, 40°÷85°, OFF) setting:
• manual steam stop
Any number between "40°÷85°" (0°, 40°÷85°, OFF)
• automatic steam stop
"OFF" (0°, 40°÷85°, OFF) setting:
• steam stop disabled
- emulsion level (a different emulsion level can be chosen
for frothed milk: the value can be set between "0 ÷ 100",
where 0 indicates no emulsion and 100 indicates continuous
emulsion).

Banner

PRELIMINARY OPERATION
N.B.: the preparation of the le to load onto the
pen drive is carried out with special software. For
further information, and for instructions on using
the software, please contact our service centre.
To access banner programming:
- position the cursor above the line "Prog. Banner";
- insert the pen drive containing the le generated with the
appropriate software into the USB port; the symbol
will appear on the display.;
- press the "PRG" (29); the machine loads the messages to
be displayed and at the end of this operation the following
message will appear on the display:
CUSTOMER PROG.
Banner Prog. OK
At the end of the operation, press the
to the work screen.
+
+
"RES" (24) to return
21 EN
12a
1 2
11
3 4