Faema Emblema Gebrauch Und Installation Seite 65

SINGLE WASHING: Cannot be carried out if the machine launches a warning message.
1
Remove the filter holder
from the coffee group.
4
Use the "+" (30) and "-" (31) keys to pass to the Sin le
Wash. An arrow will highlight the group that will be washed.
to change sel.
to con rm
6
Confirm the choice (for
example, group 3), using
the key and . The screen
will display:
I N S E R T . F I L T E R
H O L D E R
G R O U P 3
p u s h
t o c o n f i r m
10
Press the coffee circuit wash
key (26).
14
Press the coffee circuit wash
key (26).
2
Using a brush, clean the
cover gasket.
7
Insert the rubber disk into
the lter-holder with its lter.
11
The Group 3 wash cycle will
start and the "GR WASH"
message will appear on the
display.
G R 3 W A S H
15
The message "GR RINSE"
will appear.
G R 3 R I N S E
3
to change sel.
to con rm
5
Use the "+" (30) and
to be washed.
to change sel.
to con rm
8
Pour in a packet or dosing
cupful of detergent powder.
12
At the end of the group 3
wash cycle, the message
"REMOVE FILTER HOLDER
GROUP " will appear.
R E M O V E F I L T E R
H O L D E R
G R O U P 3
p u s h
t o c o n f i r m
16
The washing cycle is
complete after the rinsing
phase.
Repeat these steps for the
groups you want to wash.
25 EN
Hold down the coffee circuit
washing key (26) for a few
seconds.
The simultaneous washing
screen (preset mode) will
appear on the display.
"-" (31) keys to choose the group
9
Hook the filter holder to
Group 3.
13
Remove the lter holder.
Do not remove the lter holder
during coffee dispensing.