Use; Day-To-Day Operation; Manual Powering; Automatic Switch Off / Switch On - Faema Emblema Gebrauch Und Installation

USE

10. Day-to-day operation

"Before setting the machine at work, make sure that:
• the main electric power switch is on;
• the mains water cock has been turned on".

MANUAL POWERING

1
1 ON
Press the luminous main switch to turn
on the machine.

AUTOMATIC SWITCH OFF / SWITCH ON

The machine can be set to switch off and switch on at
programmed times. Consult the "Service time menu"
chapter to set the "ON Time" switch-on time and the "OFF
Time" switch-off time.
When a service time is set, the machine automatically
switches off at the programmed time. During the automatic
switch-off phase, the following message will appear on the
display:
MACHINE OFF
Note. When the machine is working in the automatic
on/off function do not use the general switch
(1) to switch off the machine. If this happens,
the machine will not be able to switch on again
automatically.
The machine switches on automatically at the programmed
timed. The messages displayed and the operations
performed by the machine are the same as those described
in the paragraph "MANUAL POWERING".

ENERGY SAVING STANDBY

When the machine is switched off, it can be set to the

ENERGY SAVING mode.

When this function is enabled, the machine resistance is
not completely disabled and keeps the boiler pressure at
0.2 bar.
Please consult the chapter "Service time menu" for setting
this function.
2
11 October 2013
15:40:51
3
11 October 2013
15:40:51
ENERGY SAVING MODE
The ENERGY SAVING function can also be enabled
manually if you press the key and hold it for several
seconds
During this phase:
- If the boiler pressure is set at a value exceeding 1.2 bar,
the pressure is lowered to 0.8 bar;
- If the boiler pressure is set at a value below 1.2 bar, the
pressure is lowered by 0.4 bar below the set value.
Press any dispensing key to exit the ENERGY SAVING
mode and return to the machine work phase.

FORCED SWITCH ON

Press the "STOP/Coffee continue"
seconds to force the machine on again.
Note. Forcing the machine on does not change the
Note. At this point the machine will remain on until the
To immediately return the machine to "off" as originally
programmed, switch it off and on again using the general
on-off switch (1).
10 EN
+
+
.
programmed on/off times.
next switch off time is reached.
During this phase
the boiler is loaded
and the heating
phase begin.
The preset working
pressure must be
reached before the
machine is ready
for use.
key for a few