Usb Port; Modbus Connection; Service Mode - Maico PP 45 K Installationsanleitung

UK | 12 USB port

12 USB port

The USB port is used to connect a notebook
with the room air control.
In conjunction with the commissioning soft-
ware ( Internet), settings on ventilation units
can be undertaken.

13 ModBus connection

The ventilation system can also be integrated
into the building control technology.
Your specialist installer can configure the RS
485 interface of the
control as a ModBus interface for this pur-
pose.
The interface is set in service mode or using
the commissioning software.
When using the RS-485 interface
i
as the ModBus interface,
no other components (sensors,
power units, room air controls
etc.) can be connected to this
interface.
82
RLS 45 O RLS 45 K
or

14 Service mode

● In service mode, activate the components
connected to the room air controls.
● Activate the EnOcean or ModBus interface
if RC ventilation units are connected and/or
a building control technology connection is
to be established.
● If room air controls connected in parallel are
released, service mode can be called up
from each control.
● Activate more room air controls, power
units, sensors and EnOcean modules
on the master RLS. More RLS must be
parameterised and addressed as slaves via
service mode.
● Systems with an RLS 45 K control can also
be configured using a PC (USB) and the
PP 45 commissioning software.
● The PP 45 EO EnOcean module can only
be taught in with the commissioning soft-
ware (with RLS 45 K).