Deleting Transmitters; Setting Ventilation Unit As Signal Amplifier - Maico PP 45 K Installationsanleitung

3. Send a teach-in telegram with the radio
sensor  Operating instructions of wire-
less sensor. Once teaching-in has been
successfully completed, LEARN mode is
exited.
4. Fit front cover for internal housing [1] on
the master unit such that it locks into the
safety catches. Before putting on the front
cover, the shutter must always be open.
To do this, briefly switch on the RC unit.
5. Run function test.
Teaching in radio sensor on EnOcean
extension module
When using a PP 45 EO extension module,
the teach-in/complete teaching mode must
be activated using the commissioning soft-
ware or when in service mode. For detailed
information  Chapter 14.

11.8 Deleting transmitters

1. Remove front cover [1] on the master unit.
2. Then activate teach-in mode. The 3 LEDs
flash.
3. Briefly press the LEARN key [16] twice.
The 3 LEDs flash briefly twice and then go
out (periodic process).
4. Press the LEARN key [16] (> 2 seconds)
until the 3 LEDs on the master light up for
an extended period once and then go out.
All taught-in transmitters are deleted. The
master is again in its initial state.
5. Fit front cover [1] on the master unit such
that it locks into the safety catches.
Before putting on the front cover, the
i
shutter must always be open. To do
this, briefly switch on the RC unit.
6. Make sure that the transmitters are
deleted.
PP 45 EO
11 Radio-controlled operation (EnOcean) | UK
11.9 Setting the ventilation unit as a
signal amplifier (repeater)
The radio electronics in the ventilation unit
can also be used as a signal amplifier. In this
case, the unit that is set up this way works
additionally as a signal amplifier. EnOcean
telegrams are received and forwarded in
parallel to the running application.
This can be necessary for example, with
applications in single-family houses that
are completely automated with EnOcean
products.
Settings values
● Off
● Level 1 = Original telegrams are amplified
● Level 2 = Original telegrams and telegrams
that have already been amplified are am-
plified
Setting the ventilation unit as a signal
amplifier
1. Activate teach-in mode on the receiver
(master unit). The 3 LEDs flash.
2. Briefly press the LEARN key [16] 3 times.
The 3 LEDs flash 3 times and then the red
LED flashes once (periodic process).
You are in the Repeater sub-menu. The
basic setting is Repeater OFF.
3. Press the LEARN key [18] x times for
repeater mode:
Press once: Repeater level 1: 3 LEDs
flash 3 times and then the red LED flashes
twice.
Press twice: Repeater level 2: 3 LEDs
flash 3 times and then the red LED flashes
3 times.
When the key is pressed 3 times, the
loop starts again from Repeater OFF.
4. Press the LEARN key [16] (≥ 5 seconds)
until the LEDs on the ventilation unit light
up for an extended period. The setting is
saved.
81