Pp 45 Opp 45 K Fitting Drawer Unit And Internal Cover - Maico PP 45 K Installationsanleitung

UK | 9 Mounting
Mounting PP 45 AE, PP 45 AW, PP 45 AK
1. Once the external plastering is complete,
remove the plaster protective cover.
2. Take front cover [F] off housing [G] of
external cover.
3. Align housing [G] horizontally and centred
with wall sleeve, mark 4 fixing holes,
position dowels and screw down housing
to external wall with 4 screws. Suitable
mounting material is to be supplied by the
customer.
4. Seal bottom third of spaces between wall
sleeve and housing [G] with permanently
elastic and weatherproof sealant e.g.
sealing strips [S1]) (silicone).
5. Press front cover [F] onto housing [G] so
it engages all the way round. Also secure
stainless steel front cover with a screw.
6. Seal front cover to external wall with per-
manently elastic and weatherproof sealant
 Arrows [S2]. Suitable sealing material is
to be supplied by the customer.
68
PP 45 O PP 45 K
9.3
and internal cover
After internal plastering and painting, pro-
ceed as follows.
Wall sleeves and external covers
i
are already installed.
1. Switch off mains fuse, affix warning sign
in visible location to prevent it from being
started up again.
Perform following steps for all ventilation
units
2. Take inner plaster protective cover out of
wall sleeve.
3. Check angle of inclination of fitted wall
sleeve. There must be an inclination of
1 to 2 % to the external wall.
4. Route control cables of ventilation units,
sensors and accessory components in the
empty ducts.
5. Take off front cover of internal cover's
housing. To do this, press on locking lever
on underside of housing and take off cover.
PP 45 O
6. With and
the room air control's 12 V control cable
from the rear into the internal cover's inter-
nal housing.
PP 45 RC
7. With units, route the 230 V
power cable from the rear into the internal
cover's internal housing.
8. Align housing of internal covers horizon-
tally on the wall sleeve, mark the 4 fixing
holes, position dowels and screw down
housing to internal wall with 4 screws.
Suitable mounting material is to be sup-
plied by the customer. For drilling distanc-
es of internal cover  Appendix.
Fan unit, ceramic heat exchanger
i
and filter seats with the two air filters
are already inserted in the drawer unit
in the factory. G2 filter facing internal
wall, G3 filter facing external wall. For
filter types  Chapter 18.
9. Ensure that the air filters lie flat in the
seats.
Fitting drawer unit
PP 45 K
units, route