Werbung
5
Technical Information
Sublimation Controller Outline
Remote I/O Connection (P5 connector)
An external analogue unit can be connected to the I/O connector to
set some sublimation parameters and receive feedback from the field.
It is a 9-pins Male D type connector. The pin layout is shown in the
following figure.
The correspondence between pin and signal is:
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
82/127
Figure 7
I/ O connector layout
Input signal. Voltage range 0 to 10 Vdc. Used for setting
sublimation current value between 30 A (corresponding to 6
Vdc) and 50 A (corresponding to 10 Vdc).
Input signal. Voltage range 0 to 5 Vdc. Used for setting
pressure threshold value: minimum value 1*10
(corresponding to 0 Vdc), maximum value 1*10
(corresponding to 5 Vdc).
Interlock. This pin must be shorted to one of the common
pins (number 4 or 6 to 9) (the jumper is furnished with the
controller).
Not Connected
Output signal. Voltage range 0 to 10 Vdc. Used to feedback
the sublimation current value applied during sublimation
(0 Vdc = 0 A, 10 Vdc = 50 A).
to 9. Common.
TSP Controller User Manual / 87-900-138-01
-10
mbar
-4
mbar
Werbung
Kapitel
