Interconnections; P3 - Vent; P5 - External Fan; J5 - In-Out - Agilent Technologies TV 301-P Bedienungshandbuch

INTERCONNECTIONS

The following figure shows the TV 301-P interconnections.
SERIAL LINE
MAINS
EXTERNAL
FUSE TYPE
250V T 8A
FAN
VENT VALVE
LD1
STATUS
P3 P5
J6 SERIAL
VENT
ADDRESS FAN
ADDRESS
STATUS J2 PROFIBUS
MSD LSD
STATUS

P3 - Vent

This is a dedicated 24 Vdc connector to control the
optional vent valve.
P5 – External fan
This is a dedicated 24 Vdc connector to supply the
optional external fan.
MAINS POWER
IMPUT/OUPUT LINE
TO PUMP
PROFIBUS LINE
J5 IN-OUT

J5 - IN-OUT

This connector carries all the input and output signals to
remote control the TV 301-P Navigator Controller.
It is a 15-pins D type connector; the available signals
are detailed in the table, the following paragraphs de-
scribe the signal characteristics and use.
PIN N.
1 START/STOP (+)
2 START/STOP (-)
3 INTERLOCK (+)
4 INTERLOCK (-)
5 SPEED SETTING (+)
6 SPEED SETTING (-)
7 SOFT START (+)
8 SOFT START (-)
9 +24 Vdc
10 SPARE
11 PROGRAMMABLE SET POINT
12 SPARE
13 FAULT OUTPUT
14 PROGRAMMABLE ANALOG
SIGNAL (+)
15 •
GROUND
•
PROGRAMMABLE ANALOG
SIGNAL (-)
Signal description
START/STOP: input signal to start or stop the pump.
With the supplied cover connector the START/STOP (+)
signal is connected to the +24 Vdc pin and the
START/STOP (-) signal to the GROUND pin: in this
condition the pump automatically starts as soon as the
controller recognises the input supply ("Plug & Pump").
INTERLOCK: input signal to control the pump rotation.
With the supplied cover connector the INTERLOCK (+)
signal is connected to the +24 Vdc pin and the INTER-
LOCK (-)signal to the GROUND pin.
37
TECHNICAL INFORMATION
SIGNAL NAME
OUTPUT
87-901-001-01 (A)
INPUT/
IN
IN
IN
IN
IN
IN
IN
IN
OUT
OUT
OUT
OUT
OUT