Leave at least 30 mm (1.2 inches) of free air circulation on top and bottom of
NOTE
the unit for an efficient cooling of the unit. Blind the unused slots on rear panel
with the provided covers.
Controller Interconnections
Pump Connection (J6 connector)
The pump is connected to the controller rear panel via "LOAD"
connector (cable to be separately ordered).
WARNING!
When installing the high power cable:
1
Before removing the cable make sure that the power is off.
TSP Controller User Manual
Turn the power off.
3
Plug the cable on the pump side and secure it with
the ring nut.
4
Plug the cable on the controller side and secure it
with the ring nut.
/
87-900-138-01
Technical Information
Sublimation Controller Outline
5
81/127