Werbung
Without the interlock connection the controller cannot operate. If the controller
NOTE
is not connected with a remote unit the tap furnished with the controller must
be used. If the controller is connected with a remote unit the interlock must be
correctly connected as described.
Serial Port (J2 connector)
This is a 9 pin Female D-type serial input/output connector to control
via an RS 232 or RS 485 connection the Sublimation Controller. The
pin layout is shown in the following figure.
Pin
1
2
3
4
5
6
7
8
9
TSP Controller User Manual
Figure 8
I/ O connector layout
Signal
Not connected
TX (RS232)
RX (RS232)
Not connected
GND
A + (RS485)
Not connected
B – (RS485)
Not connected
/
87-900-138-01
Technical Information
Sublimation Controller Outline
5
83/127
Werbung
Kapitel
