Werbung
4
Instructions for Use
Maintenance
Sublimation Controller Switching OFF
To switch OFF the Sublimation Controller , proceed as follows:
1
2
Maintenance
The Sublimation Controller does not require any maintenance. Any
work performed on the unit must be carried out by authorized
personnel.
WARNING!
Before carrying out any work on the controller, disconnect it from the supply.
In the case of breakdown, contact your local Agilent service center who can
supply a replacement controller.
If a controller is to be scrapped, it must be disposed of in accordance
with the specific national standards.
72/127
push the "SUBLIMATION" key located on the front panel
(blue LED extinguished)
switch the power switch located on the rear panel to the "O"
position.
TSP Controller User Manual / 87-900-138-01
Werbung
Kapitel
