5
Technical Information
Use
Use
There are three different type of settings that can be selected:
1
2
3
The unit is factory set for:
NOTE
MANUAL mode operation
source TSP
sublimation current 30 A
sublimation time 1 minute
sublimation period 3 minutes
pressure threshold 1x10
"AUTOSTART" set YES (automatic restart after shut down)
Sublimation Controller Configuration
This menu allows to set the following parameters:
To enable the Sublimation Controller Configuration menu press and
hold the MODE and SET keys on the front panel and simultaneously,
on rear panel, switch on the power.
86/127
configuration of the Sublimation Controller
operating mode selection
parameters settings.
the pump cable resistance;
the type of source (TSP or Mini Ti-Ball™ cartridge) powered by
the Sublimation Controller.
mbar
-7
TSP Controller User Manual / 87-900-138-01