Werbung
Installation
The Sublimation Controller is equipped with a 3-wire power cord and plug
WARNING!
(internationally approved) for user's safety. Use this power cord and plug in
conjunction with a properly grounded power socket to avoid electrical shock.
Verify that the ground connections are properly connected. High voltages
developed inside the controller can cause severe injury or death. Before
servicing the unit, disconnect the input power cable.
The controller can be used as a bench unit or a rack module, but it must be
CAUTION!
positioned so that free air can flow through the holes of the top and side cover. If
the Sublimation Controller is used as a rack module, it MUST be inserted in a 4
unit height rack adapter chassis to avoid collapse of the controller fall inside the
rack. The front panel of the Sublimation Controller is not designed to support the
controller weight. Do not install or use the Sublimation Controller in an
environment exposed to atmospheric agents (rain, snow, ice), dust, corrosive
gases or in explosive environments or those with a high fire risk.
If the Sublimation Controller is used as a bench unit, it must have the four side
legs. If the Sublimation Controller is installed on a rack, remove the four side
NOTE
legs and position it with at least 30 mm (1,2 inches) of clearance on top and
bottom.
During operation, the following environmental conditions must be
respected:
To connect the Sublimation Controller to the pump use the specific
cable supplied as an option. See the appendix "Technical
Information" for detailed information about the above mentioned and
other connection and about the optional card installation.
The pump cable must be always completely unrolled before switching on the
CAUTION!
Sublimation.
TSP Controller User Manual
temperature: from +0 °C to +45 °C
relative humidity: 0 – 90 % (non-condensing)
/
87-900-138-01
Instructions for Use
Installation
65/127
4
Werbung
Kapitel
