Maintenance; Cleaning; Printer Interior; Lubrication - BigRep STUDIO Betriebsanleitung

Maintenance

9
9. Maintenance

9.1. Cleaning

Print Bed Surface
WARNING – Danger of Fire
Fire danger from bed cleaning. Never clean the print bed while the print bed
heating is active! Let the surface cool down before cleaning. Completely re-
move any cleaning agents aft er cleaning.
CAUTION – Toxic Fumes
Provide adequate ventilation during and aft er cleaning the print bed. Leave
the door open aft er cleaning the print bed.
Do not use any scratchy tools/materials for cleaning. Damages in the surface
can lead to faulty print results.
Make sure that the main switch (S) is turned off !
Clean the print bed (H) with a damp, soft , and lint-free piece of cloth before print-
ing. Do not use any solvent-based detergents!
Use ethyl alcohol to remove heavy soiling. Provide adequate ventilation when us-
ing ethyl alcohol. Keep away from heat, hot surfaces, sparks, open flames and
other sources of ignition. Do not smoke at working space.
Extruder and Nozzles
Fine filament threads can occur during the printing process and should be re-
moved aft er. These threads can also get caught in the hotend ventilation. Regular-
ly check the ventilation and clean if necessary.
To clean mechanical parts from dust, spray components with compressed air.
Display
Clean the display (E) with a damp, lint-free piece of cloth. Do not use solvent-based
detergents!

Printer interior

Make sure that the main switch (S) is turned off ! Clean the interior space if neces-
sary. Open the service hatch (J) to remove remaining filament from interior.

9.2. Lubrication

Make sure that the main switch (S) is turned off !
88
BigRep STUDIO