BigRep STUDIO Betriebsanleitung Seite 79

BigRep STUDIO
Resume from Power Outage
If due to power outage, human error or other electrical disturbance the machine
loses power or control, you may be able to continue the print.
After restarting the machine, the following message will appear:
Choose one option:
Resume Print: Printer will start a resuming procedure.
›
It will reset the temperatures of the bed and extruder.
›
It will start the Home-To-Max procedure to identify its position:
– The extruders will move up to the highest Z position (Zmax), then home
X and Y.
– The printer will automatically move back down again to 10mm above
the stopped location to heat the nozzle and prepare to print.
After this procedure
›
Go to the Temperature Menu and check that the bed and the extruders
have reached their correct temperatures.
›
It is recommended to extrude 100mm to verify material quality and flow
›
Click on the Start Print button to resume the print.
Cancel Print: The UI will go to the standard menu, and the print will not be recov-
ered.
Fig. 7-10: Resume Print
Operation and Control
7
79