Inhaltsverzeichnis; Task 1: Unpacking The Vtrak (Below) - Promise Technology VTrak series Kurzanleitung

VTrak Task List
• Task 1: Unpacking the VTrak (below)
• Task 2: Mounting the VTrak Unit in a Rack (page 5)
• Task 3: Installing Disk Drives (page 8)
• Task 4: Making Data Connections (page 13)
• Task 5: Setting Up Serial Cable Connections (page 17)
• Task 6: Connecting the Power (page 18)
• Task 7: Setting Up the CLI Connection (page 19)
• Frequently Asked Questions (page 20)
• Contacting Technical Support (page 21)
Thank you for purchasing a Promise VTrak J830s or J630s external disk
subsystem.
Please read through these instructions completely before you begin. You might
need additional items to complete your installation.
Task 1: Unpacking the VTrak
The VTrak J830s or J630s box contains the following items:
• VTrak Unit
• Quick Start Guide
• RJ11-to-DB9 serial data cables
(2)
• 1.0m (3.3 ft) SFF-8088 4X to 4X
external SAS cables (2)
The electronic components within the VTrak are sensitive to
damage from Electro-Static Discharge (ESD). Observe
appropriate precautions at all times when handling the VTrak or its
subassemblies.
VTrak supports disk drive hot-swapping. To avoid hand contact
with an electrical hazard, do not remove more than one drive
carrier a time.
• Screws for disk drives
(J830s: 106, including 10 spares)
(J630s: 70, including 6 spares)
• Left and right mounting rails
• 1.5m (4.9 ft) Power cords (2)
• CD with Product Manual and Quick
Start Guide
Warning
Caution
3