Mounting And Connection - Sygonix 1717531 Bedienungsanleitung

7. Mounting and connection

Do not mount or connect the product when it is connected to a power supply.
• Remove the mounting plate on the back of the code lock (for example, use a small flat screw-
driver to gently pry the mounting plate off the code lock).
• Attach the mounting plate to a wall using suitable
screws. Depending on the surface, dowels may
also be required.
The mounting plate must be mounted so
that the screw hole for the fixing screw
points downwards.
Ensure that no cables or wires are dam-
aged when drilling holes or tightening
screws.
• Wire the connection cables as shown in chapter
6. Pay attention to a suitable insulation (e.g. heat
shrink tubing).
• For the connection of a door opener, a protective
diode and a varistor are used according to the
following diagram. These components protect
the code lock from damage caused by voltage peaks.
Note: The supplied varistor can only be used if the code lock is operated with an input
voltage of 12 V/DC.
34